Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) 204 smr2009-029 FAULT CODE MODULE DESCRIPTION POSSIBLE CAUSE SERVICE ACTION P0358 ECM Ignition Power Stage fault - short circuit to V+/Cylinder 2 Damaged coil, damaged circuit wires, damaged connector or damaged ECM output pins Check for 0.85 to 1.15 ohms between engine connector pin 1 and ECM connector pin A-M2. Check for 12 volts on pin 2 of coil connector. Check fuse 8 (refer to WIRING DIAGRAM). Refer to the Service Manual for more details.

P0359 ECM Ignition Power Stage fault - short circuit to V+/Cylinder 3 Damaged coil, damaged circuit wires, damaged connector or damaged ECM output pins Check for 0.85 to 1.15 ohms between engine connector pin 3 and ECM connector pin A-M1. Check for 12 volts on pin 2 of coil connector. Check fuse 9 (refer to WIRING DIAGRAM). Refer to the Service Manual for more details. P0512 ECM Starter power stage detects high current Damaged solenoid, damaged circuit wires, damaged connector or damaged ECM Verify 5 A fuse. Check for 12 volts on pin 2 of the starter relay. Refer to the Service Manual for more details. P0513 ECM Invalid D.E.S.S. Key detected Key not programmed in ECU Program a good key.

P0520 ECM Oil pressure switch functional problem Engine leak, oil pump failure, damaged sensor, damaged circuit wires, damaged connector or damaged ECM pins Check resistance at 0 RPM and above 3500 RPM. Switch is normally closed, ECM connector pin A-E3. When blow-by pressure exceeds 40 kPa (6 PSI), the resistance is infinitely high. Refer to the Service Manual for more details. P0523 ECM Oil pressure sensor fault Engine leak, oil pump failure, damaged sensor, damaged circuit wires, damaged connector or damaged ECM pins. Fault detected when the engine is running or stopped Check resistance at 0 RPM and above 3500 RPM.

When blow-by pressure exceeds 40 kPa (6 PSI), the resistance is infinitely high. Refer to the Service Manual for more details. P0524 ECM Low oil pressure condition Low oil level, engine leak, oil pump fault. Check oil level. Check impedance of sensor. Refer to the Service Manual for more details. P0544 ECM Exhaust gas temperature sensor functional problem Damaged sensor, damaged circuit wires, damaged connector or damaged ECM output pins Check for approximately 2280 to 2736 ohms at temperature of 19 to 21°C (66 to 70°F) between system circuits A-H4 and A-J4. Refer to the Service Manual for more details.