Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) smr2009-029 205 FAULT CODE MODULE DESCRIPTION POSSIBLE CAUSE SERVICE ACTION P0545 ECM Exhaust gas temperature sensor shorted to ground Damaged sensor, damaged circuit wires, damaged connector or damaged ECM output pins Check for approximately 2280 to 2736 ohms at temperature of 19 to 21°C (66 to 70°F) between system circuits A-H4 and A-J4. Refer to the Service Manual for more details.

P0546 ECM Exhaust gas temperature sensor open circuit or shorted to battery Damaged sensor, damaged circuit wires, damaged connector or damaged ECM output pins Check for approximately 2280 to 2736 ohms at temperature of 19 to 21°C (66 to 70°F) between system circuits A-H4 and A-J4. Refer to the Service Manual for more details. P0560 ECM Battery voltage not plausible Battery failure, rectifier failure, damaged circuit wires, battery terminal connection, damaged AC generator or damaged connectors Check fuses 15 (refer to WIRING DIAGRAM). Check ground continuity to the engine block. Refer to the Service Manual for more details.

P0562 ECM Battery voltage too low Battery failure, rectifier failure, damaged circuit wires, battery terminal connection, damaged AC generator or damaged connectors Check fuses 15 (refer to WIRING DIAGRAM). Check ground continuity to the engine block. Refer to the Service Manual for more details. P0563 ECM Battery voltage too high Battery failure, rectifier failure or battery terminal connection Check for regulator-rectifier failure. Refer to the Service Manual for more details. P0564 Cluster Cruise switch fault The cruise switch is shorted or activated more than 60 seconds Verify the cruise switch if it is normally open and close when activated.

P0606 ECM ECM ADC fault Damaged ECM Replace ECM. P060D ECM TAS (Throttle Accelerator sensor) synchronization error Damaged sensor, damaged circuit wires, damaged connector or damaged ECM pins Check system circuits B-E1, B-K1, B-K3, B-A3, B-B3, B-J3. Check for 0 volt on sensor connector pin B & E. Check for 5 volts on sensor connector pin A & D. Check for 0.5 to 3 volts on sensor connector pin F and 0.25 to 1.5 on C. Refer to the Service Manual for more details.

P060E ECM Throttle Actuator - Controller Fault- digital position control exceeds limit P0610 ECM Variant coding fault P0629 Cluster Fuel sensor disconnected fault Damaged sensor, damaged circuit wires, damaged connector or damaged ECM output pins Check for 2.6 ohms (full tank) to 93.6 ohms (empty tank) between pin C and pin D at the fuel pump connector. Check system circuit at the gauge Pin 2 and 3 (refer to WIRING DIAGRAM).