Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 01 (INTELLIGENT THROTTLE CONTROL (iTC)) smr2009-042-002_a 1. Gauge connector 2. Pull out to unlock connector smr2009-036-002_b 1. Read Data 2. Monitoring tab 3. Cluster tab 4. Cruise indicator light 6. Use the FLUKE 115 MULTIMETER (P/N 529 035 868) . 7. Select the (ohm) function. 8. Test the cruise button switch as per following table. If the test succeeded, the switch and wiring are good and the problem may be related to the in- formation center or ECM. Check for related fault codes. Refer to MONITORING SYSTEM AND FAULT CODES. If the test failed, replace the cruise switch. If the test succeeded, the problem may be internal to the information center.

Try a new one. Cruise Switch Replacement 1. Disconnect information center connector. smr2009-036-012_b 1. Cruise indicator light If the test failed, test the switch and wiring as de- scribed in the following steps. 4. Remove the gauge support cover. Refer to GAUGE subsection. 5. Disconnect the gauge connector. NOTICE Pull connector lock out sideways. Do not twist the screwdriver. smr2009-042-002_a 1. Gauge connector 2. Pull out to unlock connector 2. Remove terminal 7 (GRAY wire) and 10 (BLACK wire) from the gauge connector. smr2009-050 217 CRUISE SWITCH TEST GAUGE CONNECTOR SWITCH POSITION RESISTANCE Pin 7 Pin 10 Switch released OL Switch depressed Close to 0