Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 03 (FUEL TANK AND FUEL PUMP) WARNING If a leak is found, do not start the engine. Wipe off any fuel that leaked and ventilate the hull thoroughly to remove any accu- mulated fuel vapors. Do not use electric powered tools on watercraft unless system has passed the leak test. Open fuel tank cap to release pressure in fuel tank. smr2009-031-102_a TEST SETUP Slowly apply pressurized air close to the pressure specification. Check Valve and Pressure Relief Valve Test Pressure Relief Valve Function Test Valve is checked when performing the FUEL TANK LEAK TEST. NOTICE Do not exceed the specification when pressurizing the fuel tank.

Bring the test pressure to the specification by manually pumping the vacuum/pressure pump. WARNING If pressure relief valve is stuck, the pressure in fuel system will build up and it may cause fuel leakage in engine compartment. When replacing valve, always reinstall it with the arrow pointing as shown. If the pressure drops, locate fuel leak(s), repair/re- place leaking component(s) and carry out a new fuel system leak check to validate repair and en- sure there are no other leaks. NOTE: Possible leak areas:

Inlet valve, fuel tank, fuel tank neck, fuel tank cap, fuel pump gasket, vent hoses, connections and valves, filler hose and connections, fuel hose and connections, fuel rail and injector(s). To locate a leak, check for a fuel smell or leaking fuel. If a fuel smell is detected but a leak is not visible, spray a soapy water solution on components to ease locating the leak(s); bubbles will indicate leak location(s). NOTE: If pressure does not stand and no leak has been found, it is likely a leaking fuel injector. Refer to ELECTRONIC FUEL INJECTION. smr2009-031-016_a Reinstall valve in its grommet. Inlet Check Valve Test Disconnect vent hose from fuel pump.

NOTICE When the fuel system leak test is complete, thoroughly rinse all components of the soapy water solution with clear water. A soapy water residue may cause premature deterioration and must be rinsed away. smr2009-031-014_a 1. Disconnect here 260 smr2009-031 FUEL TANK LEAK TEST PRESSURE TIME WITHOUT PRESSURE DROP 21 kPa (3 PSI) 10 minutes