Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 03 (FUEL TANK AND FUEL PUMP) smr2009-030-024_a 1. Throttle body 2. Inlet hose 3. Connector Remove D.E.S.S. key from its post to prevent en- gine starting. Press START button. The fuel pump should run for 2 seconds to build up fuel system pressure. If fuel pump runs, carry out the FUEL PUMP PRESSURE TEST in this subsection. If the fuel pump does not run: Ensure ECM is powered. Refer to ELEC- TRONIC FUEL INJECTION subsection. Check fuse F6. If fuse is faulty, replace it and repeat test. If fuse is good, carry out the FUEL PUMP INPUT VOLTAGE TEST in this subsec- tion. Reconnect throttle body connector.

smr2008-022-017_b If battery voltage is read, power circuit is good. Test the fuel pump circuit. Refer to FUEL PUMP CIRCUIT TEST. If battery voltage is not read, power circuit is faulty. Test continuity of power circuit between fuse box #1 and fuel pump. Fuel Pump Circuit Test Reconnect the fuel pump harness connector. Remove cover of fuse box #1. Refer to POWER DISTRIBUTION subsection. Remove the long bus bar. Fuel Pump Input Voltage Test Disconnect fuel pump harness connector. Refer to FUEL PUMP REMOVAL. Use the FLUKE 115 MULTIMETER (P/N 529 035 868) . Select Vdc. Press START button. Read voltage at fuel pump harness connector as per following table. smr2009-027-011_f 1.

Long bus bar Remove ECM connector B and install it on the ECM ADAPTER TOOL (P/N 529 036 166) . smr2009-031 265 INPUT VOLTAGE TEST TEST PROBES VOLTAGE Pin B (+ probe) Battery ground (- probe) Battery voltage