Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 03 (FUEL TANK AND FUEL PUMP) smr2009-031-008_a 1. Ventilation box smr2009-031-022_a 1. Fuel pump module socket 2. Fuel pump retaining nut Disconnect the negative battery terminal, refer to CHARGING SYSTEM subsection. Disconnect fuel pump electrical connector. Disconnect the vent tube from the fuel pump. Wrap shop rags around the high pressure fuel hose fitting, then press on the release button of the quick connect fitting and disconnect the hose. NOTICE While pulling out the fuel pump module, pay attention to the corrugated tubes and fuel sensor float arm. Float arm can get caught up and bend which will reduce fuel sen- sor accuracy.

If fuel pump module is dropped or damaged, it must be replaced. Slowly pull fuel pump module up through opening until corrugated tubes contact sides of opening. Tilt the fuel pump module as you slowly pull the pump upwards. WARNING The upper filter and fuel pump reservoir on the fuel pump module contain fuel which will drain out when fuel pump module is not in an upright position. Carefully pull fuel pump module out. smr2009-031-017_b 1. Quick connect fitting (high pressure fuel hose) 2. Vent hose 3. Harness connector Unscrew the fuel pump retaining nut using the FUEL PUMP MODULE SOCKET (P/N 529 036 125) . smr2009-031-023_a 1. Pull out fuel pump module smr2009-031 267