Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 03 (FUEL TANK AND FUEL PUMP) WARNING Always wipe off any fuel spillage from the watercraft. When working with fuel or fuel system and its components, always work in a well ventilated area. Fuel Pump Installation Reverse the removal procedure however, pay at- tention to the following. Carefully insert fuel pump module in fuel tank so as not to bend float arm. Install a new fuel pump module gasket each time the module is reinstalled. NOTE: Wipe off parts to prevent fuel pump from turning while torquing fuel pump nut. Align arrow on top of fuel pump module with index mark on top of fuel tank or fuel sensor accuracy will be affected. NOTE:

Index mark and arrow locations are high- lighted for clarity in following illustration. smr2009-031-025_a 1. Fuel filter Fuel Filter Removal NOTE: The lower fuel filter on the fuel pump mod- ule does not require replacement under normal operating conditions. Replace only if permanently clogged or damaged. Remove fuel pump. Refer to FUEL PUMP in this subsection. WARNING The upper filter and fuel pump reservoir on the fuel pump module contain fuel which will drain out when fuel pump module is not in an upright position. Turn fuel pump upside down. Using a small flat screwdriver, pry up the filter locking tabs. smr2009-031-024_a FUEL PUMP MODULE INDEXING 1.

IAlign marks Apply torque values as per exploded view. Carry out a FUEL TANK LEAK TEST and a FUEL SYSTEM HIGH PRESSURE LEAK TEST. See pro- cedures in this subsection. FUEL FILTER Fuel Filter Inspection Check if fuel filter is dirty. If so, replace it. smr2008-022-013_a 1. Fuel filter locking tab (x2) 2. Filter locking pin (x2) Pull filter off fuel pump reservoir housing. Fuel Filter Installation Align new filter with pump reservoir housing. 268 smr2009-031