Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 03 (IGNITION SYSTEM) smr05-015-002_b SECONDARY WINDING sbs2009-011-001_a 1. Apply product here If any test failed, replace ignition coil. 3. Pull rubber seal back on its seat making sure the tabs on the ignition coil and the slots in the seal properly match together. 4. Leave a ring of grease on top of the seal as shown to act as a water barrier. Wipe off the excess. Ignition Coil Removal Open seat. Remove rear ventilation box. Refer to AIR INTAKE SYSTEM. Disconnect ignition coil connector. NOTICE Do not remove the ignition coil be- fore disconnecting the input connector or the wires may be damaged.

Do not pry up ignition coil with a screwdriver to avoid damage. NOTE: Twist ignition coil in both directions as you pull it up to ease removal. Remove ignition coil from spark plug. Ignition Coil Installation Prior to inserting the ignition coil on its spark plug, apply sealant as described in following procedure: 1. Pull rubber seal down. sbs2009-011-003_a 1. Correctly shaped excess of product 5. Apply DOW CORNING 111 (P/N 413 707 000) on rubber seal contact area. smr05-015-002_d 1. Apply product here sbs2009-011-002_a 1. Rubber seal pulled down 6. Install coil in cylinder head hole. 7. Push the ignition coil down to securely install it on the spark plug tip. 8.

Ensure the seal seats properly with top surface of engine valve cover. 2. Apply DOW CORNING 111 (P/N 413 707 000) to rubber seal seat as shown. smr2009-032 293 CIRCUIT TERMINAL RESISTANCE @ 20°C (68°F) Secondary winding 1 and spark plug terminal 9.5 - 13.5 k