Section 05 ELECTRICAL SYSTEM Subsection 03 (IGNITION SYSTEM) Unscrew spark plug then use the ignition coil to take spark plug out of spark plug hole. smr2009-032-004_a 1. Seal properly seated SPARK PLUGS Spark Plug Removal Open seat. Remove rear ventilation box. Refer to AIR INTAKE SYSTEM. Disconnect the ignition coil input connector. Remove ignition coil. Refer to IGNITION COIL RE- MOVAL in this subsection. smr2009-032-003_a 1. Ignition coil 2. Spark plug Troubleshooting a Fouled Spark Plug Fouling of the spark plug is indicated by irregular running or misfiring of the engine, decreased engine speed due to misfiring, reduced perfor- mance, and increased fuel consumption.
Other possible causes are: a incorrect or bad fuel, defective ignition system, incorrect spark plug gap, loss of compression, or lubricating oil entering the combustion chamber. The plug face of a fouled spark plug has either a wet or dry black carbon deposit. Such coatings form a conductive connection between the center electrode and the ground electrode. WARNING Never remove an ignition coil from a spark plug without disconnecting it from the wiring harness. Flammable vapors may be present in the bilge. Should the safety lanyard be in- stalled on the D.E.S.S. post, a spark could be generated at the coil spark plug end which could cause an explosion.
Using a spark plug socket, release the torque ap- plied to the spark plug. Spark Plug Analysis TYPICAL 1. Overheated (light grey, white) 2. Normal (light brown, brown) 3. Fouled (black, wet or dry, dark deposits, grey, melted coating) The plug face reveals the condition of the engine, operating condition, method of driving and fuel mixture. For this reason it is advisable to inspect 1. Approved socket 2. Improper socket Clean the spark plug and cylinder head with pres- surized air. 294 smr2009-032