Section 05 ELECTRICAL SYSTEM Subsection 05 (STARTING SYSTEM) smr2009-034-008_a If test failed, replace solenoid. If test succeeded, perform the following test. Disconnect battery negative cable. Test solenoid main contacts as per following table. smr2009-034-006_c If test failed, repair or replace wiring/connectors. If test succeeded, carry out a SOLENOID COIL RESISTANCE TEST Solenoid Coil Resistance Test Plug harness connector to solenoid. Remove relay in fuse box 2. Disconnect the B connector from ECM. Install ECM ADAPTER TOOL (P/N 529 036 166) on ECM connector. Set multimeter to setting. Measure solenoid coil resistance as per following table.
smr2007-025-004_a TYPICAL SOLENOID MAIN CONTACTS TEST (BATTERY DISCONNECTED) If test failed, replace solenoid. If test succeeded, perform a SOLENOID DY- NAMIC TEST. Reconnect battery cable. smr2009-034 319 SOLENOID CONTROL CIRCUIT TEST SOLENOID CONNECTOR ECM CONNECTOR B RESISTANCE Pin B B-L4 Close to 0 (continuity) SOLENOID MAIN CONTACTS TEST SOLENOID POSTS RESISTANCE Post coming from battery Post going to starter OL (open circuit) SOLENOID COIL RESISTANCE TEST FUSE BOX 2 ECM CONNECTOR B RESISTANCE Terminal A10 B-L4 Close to 0 (continuity)