Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 07 (GAUGE) Information Center Installation Installation of the information center is the reverse of the removal procedure. However, pay attention to the following. 1. Insert and align the bottom of the gauge into the support first, then push the top into the sup- port and ensure it properly locks into the retain- ing tab. 2. When reinstalling the gauge support cover, first insert the top of the cover into the sup- port. Then align the bottom of the cover with the locking tabs on the outside of the gauge support and push it in until it snaps back in place. 3. Apply a small amount of DIELECTRIC GREASE (P/N 293 550 004) to the gauge connector pins. NOTE:

If you are installing a replacement informa- tion center, refer to INFORMATION CENTER RE- PLACEMENT in this subsection. smr2009-042-067_a 1. LH side tab 2. Upper retaining tabs 5. Disconnect the gauge connector. NOTICE Pull connector lock out sideways. Do not twist the screwdriver. Information Center Replacement NOTICE Before replacing the information center, it is very important to retrieve the "approximate time left to Supercharger main- tenance" in B.U.D.S. (on the Vehicle page), and to advise the customer when the watercraft needs to be brought in for supercharger main- tenance.

The new information center will start count- ing the "supercharger time to maintenance due hours" from zero as the hours are calculated and stored in the gauge cluster (old cluster), not in the ECM. The SUPERCHARGER MAINTENANCE REQUIRED indicators will then come on past the real maintenance due hours. Indicated engine hours in new gauge will be correct as they are calculated in the ECM. 1. Connect watercraft to the latest B.U.D.S. soft- ware, refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE. 2. Select the Read Data button. 3. In the Run Time field of the vehicle page, note the accumulated Total Hours and the Super- charger maintenance (Approximate time left) hours. smr2009-042-002_a 1.

Gauge connector 2. Pull out to unlock 6. Insert a flat screwdriver between the upper gauge locking tab and gauge support. smr2009-036-010_a GAUGE REMOVAL 1. Insert screwdriver here 7. Hold back of the gauge with one hand and care- fully compress the retaining tab to release the information center from the gauge support. 350 smr2009-036