Section 05 ELECTRICAL SYSTEM Subsection 07 (GAUGE) 5. Remove the battery (with holder) from the wa- tercraft, refer to CHARGING SYSTEM. WARNING Always disconnect the battery cables exactly in the specified order, BLACK (-) battery cable first then the RED (+) cable last. 6. Unlock the depth sounder clocking tabs from the battery holder base and pull the depth sounder out from the base. ssi2009-002-013_a 1. Gel pad 2. Depth sounder Depth Sounder Installation 1. Insert the depth sounder in the battery holder base while paying attention to the position of the wiring on the sounder with the groove in the battery holder base. 2.
Press firmly on the depth sounder until both locking tabs are locked into the base. 3. Connect the sounder connector to the wiring harness and route the wiring in the groove pro- vided in the battery holder base. ssi2009-002-014_a 1. Locking tabs 2. Battery holder base 7. Disconnect the depth sounder connector from the wiring harness. Depth Sounder Inspection Ensure the silicone pad is in good condition. NOTE: There must not be any air trapped be- tween the bottom of the depth sounder and the bilge. Otherwise, the sounder will not function correctly. If the silicone gel pad is damaged, replace it. Depth Sounder Gel Pad Replacement 1.
Place the flat side of the depth sounder on a level surface. 2. Remove the old gel pad from the bottom of the depth sounder. 3. Clean the concave surface of depth sounder. 4. Remove both protectors from the gel pad. 5. Apply gel pad on depth sounder. ssi2009-002-014_b 1. Depth sounder connector 2. Wiring harness 4. After installation: 4.1 Try pulling the sounder out to ensure it is properly locked in the battery support base. 4.2 Try pushing on depth sounder. You must feel a resistance (no air gap). NOTE: An air gap can be eliminated by adding an additional gel pad. 5. Install the battery and electrical component support in the reverse order of removal, refer to CHARGING SYSTEM.
NOTICE Make sure do not trap air between gel pad and depth sounder. Otherwise, the de- vice will not work. 356 smr2009-036