Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) NOTE: The iBR lever must be pulled in at least 25% of its travel (approximately) before the iBR gate starts to move. The first 25% of iBR lever travel has no effect on the iBR gate. Every time the iBR gate moves when commanded by the iBR lever, engine RPM is momentarily re- duced to idle speed as the gate moves. Braking Mode If the watercraft speed is 8 km/h (5 MPH) per hour and above when the iBR lever is pulled in, braking mode is engaged. When the iBR lever is pulled in to engage braking, the following occurs: Engine RPM is reduced to idle. The iBR gate moves to the maximum down po- sition.
Engine RPM ramps up to the engine power commanded by the iBR lever. When operating in braking mode, the iBR gate al- ways moves to the maximum down position. The throttle lever signal is overridden and engine RPM is now dependent on watercraft speed and how far the iBR lever is pulled in. If watercraft speed is high when braking is ap- plied, engine power will be initially low and then ramp up to the power commanded by the iBR lever position. The engine RPM may be in- creased, as necessary, to apply a stronger braking effect with the jet pump thrust when the condi- tions dictate. As the watercraft slows to less than 8 km/h (5 MPH), the following occurs: Braking mode ceases.
Reverse mode takes over if the iBR lever is not released. Throttle control reverts back to the throttle lever. WARNING If it is necessary to remove any foreign ob- ject caught in the iBR gate, nozzle or linkages, strictly observe the following before proceed- ing: Remove D.E.S.S. key from post. Wait at least 5 minutes. Do not press on START/STOP button. If START/STOP button is pressed, wait an- other 5 minutes. Forward Mode To engage forward: Start engine Tap on the throttle lever. The iBR gate will automatically move to the for- ward position (full up). NOTE: The full up position of the iBR gate is de- pendent on the selected VTS trim position.
Reverse Mode If the watercraft speed is below 8 km/h (5 MPH) when the iBR lever is pulled in, reverse mode is engaged. When the iBR lever is pulled in to engage reverse, the following occurs: Engine RPM is reduced to idle. The iBR gate moves to the reverse position. Engine RPM ramps up to the engine power commanded by the throttle lever. When operating in reverse mode, the iBR lever controls the iBR gate position and the engine RPM is controlled by the throttle lever. The iBR gate position can be modulated anywhere between the neutral and full reverse positions de- pending on the position of the iBR lever.
If the iBR lever position is varied during reverse opera- tion, engine RPM is reduced to idle every time the iBR gate moves. It is therefore recommended to maintain the iBR lever completely pulled in. Maximum engine RPM in reverse is 5000 RPM. Neutral Mode Every time the iBR lever is pulled in and released, the iBR gate will default to the neutral position except if the throttle lever is still pulled in when the iBR lever is released. If the throttle lever is still pulled, the iBR gate will move to the forward position when the iBR lever is released and the watercraft will accelerate forward.
iBR Override Function To permit easy access to the jet pump, nozzle, iBR gate, and various linkages for inspection, mainte- nance, cleaning or removal of debris, the iBR sys- tem provides for an iBR override function which, is accessible through the information center. When iBR override is activated, it allows the user to electrically move the iBR gate and nozzle through its full range of motion using the VTS control button. 376 smr2009-037