Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) WARNING When moving the iBR gate using the iBR override function, ensure nobody stands near the rear of the watercraft. Movement of the gate may squeeze fingers. SYSTEM DESCRIPTION (VTS) This watercraft is equipped with a programmable high performance VTS (Variable Trim System). The VTS system is actually part of the iBR system. It provides watercraft pitch trim adjustments by adjusting the vertical position of the jet nozzle. The VTS can be manually trimmed to desired atti- tude, or to one of two preset trim positions. Press VTS control button (up or down arrow) to adjust riding attitude of the watercraft. smo2009-002-114_hh 7.
Press the UP/DOWN arrow button (RH handle- bar) to display OVR ON. smo2009-002-114_gg sdd2009-001-019_c TYPICAL - VTS CONTROL 1. Bow up 2. Bow down 8. Press the SET button to select the OVR ON function. The gauge will return to its normal dis- play. 9. Press the VTS UP or DOWN arrow button to move the iBR gate. The VTS switch sends command signals to the gauge. The gauge converts them to CAN proto- cols and sends them through the CAN bus to the iBR module on the iBR actuator. The actuator then moves the iBR gate which moves the nozzle to the desired trim position. NOTE: The nozzle and iBR gate move together in the VTS trim range up to the maximum noz- zle down position.
If NEUTRAL, BRAKING or RE- VERSE is engaged, the iBR gate moves past the VTS full down position. When FORWARD thrust is reengaged, the nozzle and iBR gate move up to the last selected VTS trim position. The nozzle trim position can be seen on the VTS position indicator in the information center. NOTE: Changing the VTS trim position without the engine running in forward thrust mode only changes the indication. The nozzle will move to the selected VTS trim position when forward thrust is engaged. Deactivating iBR Override Function To deactivate the iBR override function, carry out one of the following: 1. Repeat previous steps and press the SET but- ton when OVR OFF is visible. 2.
Wait for the electrical power to shut off (wait 4 minutes). 3. Start the engine. NOTE: When the engine is started, the iBR OVR function is deactivated and the iBR gate will move to the neutral position. 378 smr2009-037