Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) smr2009-038-026_a PULL DOWN SLIGHTLY ON iBR GATE sdd2009-001-042_a INFORMATION CENTER VTS POSITION INDICATOR 1. Bow up 2. Bow down 3. Using a machinists ruler, measure the distance between the bottom of the guard and the trailing edge of the iBR gate (example 48 mm (1.89 in)). Note as measurement "A". NOTE: Only the segment indicating the relative position of the VTS will be on. The illustration shows all segments on as can be seen during the self test function. MAINTENANCE iBR GATE BACKLASH CHECK 1. Using the iBR override function, move the iBR gate to the up position. Refer to SYSTEM DE- SCRIPTION (iBR) in this subsection.
smr2009-038-018_a 1. iBR guard 2. Measurement "A" 4. Without using excessive force, push up on the trailing edge of the iBR gate to pick up the backlash in the gate mechanism. As you hold the gate up, measure the distance between the trailing edge of the guard and the trailing edge of the iBR gate again (example 41 mm (1.61 in). Note as measurement "B". smr2009-038-017_a 1. iBR gate moved to up position 2. Take hold of the lower edge of the iBR gate and pull down on it slightly, then release it. smr2009-037 379