Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) 7. Check iBR gate backlash and gate operation af- ter parts replacement and reassembly. FRICTION SLEEVE REPLACEMENT The 4 friction sleeves on the VTS trim ring should be replaced if they show signs of advanced wear (flat spots), or every 100 hours as per the mainte- nance schedule. smr2009-038-019_a 1. iBR guard 2. Lift up on iBR gate 3. Measurement "B" 5. Subtract measurement "B" from "A" to obtain the iBR gate backlash (A - B = iBR gate back- lash). Example: 48 mm - 41 mm = 7 mm 1.89 in - 1.61 in = 0.28 in. smr2009-038-021_a 1. Worn friction sleeve (flat spot) 1.
To replace the friction sleeves, remove the iBR gate and VTS ring as an assembly, refer to iBR GATE AND VTS RING REMOVAL in this subsec- tion. 6. Ensure iBR gate backlash is within specified limits. If backlash is excessive, inspect and replace iBR gate parts as required in the following order: 1. iBR locking sleeve (iBR key) 2. Friction sleeves 3. Bushings 4. Contact points (VTS trim ring, "U" arm, iBR gate) 5. iBR actuator. NOTE: Look for rotation of the locking sleeve and "U" arm as you move the iBR gate by hand which may indicate excess play in the iBR actu- ator mechanism. Always replace the iBR locking sleeve first and recheck iBR backlash.
If the backlash is still not within specification af- ter replacing the iBR locking sleeve, continue dis- assembly of the iBR gate replacing the previously listed parts as required. NOTE: If the contact points on the VTS trim ring and "U" arm are excessively worn, or the friction sleeve cams in the "U" arm are worn, replace them as required. smr2009-038-013_a 1. Friction sleeves (2 each side) 2. Remove the worn friction sleeves from the VTS ring and install new ones. 3. Apply service products, torques, and install new screws with Scotch Grip threadlocker as specified in exploded view. 380 smr2009-037 iBR GATE BACKLASH A - B = BACKLASH MAXIMUM 25 mm (.98 in)