Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) Check the 30 A iBR power fuse in FB2 and the 5 A iBR control fuse in FB1 if the gate did not move using the iBR OVERRIDE function. Connect the watercraft to B.U.D.S. to check for iBR system or CAN bus related fault codes. Carry out service actions as indicated in B.U.D.S. If a CAN bus communication fault with the iBR module is indicated, or the iBR module is not visible in B.U.D.S., carry out a continuity test of the CAN bus wires between the iBR module and the CAN bus-bars in FB2. Refer to CON- TROLLER AREA NETWORK (CAN) subsection. Try moving the iBR using the iBR UP and iBR DOWN s on the iBR activation page in B.U.D.S.
Carry out an iBR SYSTEM FUNCTIONAL TEST to check for proper gate and actuator move- ment. Visually inspect system connectors for mois- ture ingress, corrosion, and proper contact. Check for excessive backlash in the gate mech- anism. Remove the locking sleeve (iBR key) and en- sure it is in good condition. Move the gate up and down by hand to check for freedom of movement. Step 1: Press START/STOP button Step 2: Install D.E.S.S. key sdd2009-001-019_g NOTE: Electrical power will shut off after approx- imately 3 minutes. Briefly press the START/STOP button to reactivate the electrical system when re- quired. 3. Set the suspension to its maximum height by double clicking the iS UP button.
This will pro- vide better access to the steering connectors. PROCEDURES iBR LEVER SENSOR (BRLS) BRLS Test Using B.U.D.S. NOTE: The BRLS is composed of a twin hall ef- fect sensor. A resistance test of the sensor can- not be carried out. 1. Connect watercraft to the latest B.U.D.S. soft- ware, refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE. 2. Check for an applicable fault code, refer to MONITORING SYSTEM AND FAULT CODES. 3. If a fault is indicated, follow service actions as indicated in B.U.D.S. sdd2009-001-019_f Step 1: Suspension to maximum height by pressing and holding the iS UP NOTE:
If more height is required or if the iS sys- tem cannot be used, manually lift the suspension using a hoist and the anchor points close to han- dlebars. Then safety lock it in the up position. NOTICE Do not lift the watercraft using the anchor points. BRLS Voltage Test Test for BRLS input voltage as well as BRLS signal voltages as per following steps. 1. Press the START/STOP button. 2. Install the D.E.S.S. key to energize the electrical system. NOTE: DO NOT start engine. 4. Open the front storage compartment cover and remove the storage bin. smr2009-037 383