Section 02 ENGINE Subsection 01 (ENGINE REMOVAL AND INSTALLATION) smr2009-016-014_a 1. Cut this locking tie 2. MATS sensor 3. Vehicle harness smr2009-016-017_a 1. Ride plate hoses 2. Water pump housing 23. At the rear of engine, unplug the magneto connector and detach connector housing from ECM support. 26. Install a suitable lifting device. smr2009-016-018_a 1. Engine lifting brackets smr2009-016-015_a 1. Magneto connector 2. Connector housing 27. Remove front engine support screw. 24. Disconnect air intake hose from throttle body. smr2009-016-019_a 1. Front engine support screw smr2009-016-016_a 1. Air intake hose 2. Throttle body 28. Remove the rear starboard engine support screw. 25.
Disconnect ride plate hoses from water pump housing. 18 smr2009-016