Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) iBR Actuator Input Voltage Test 1. Disconnect the 3 pin and 12 pin connectors from the iBR actuator. sdd2009-001-019_c 1. VTS UP 2. VTS DOWN NOTE: Electrical power will shut off after approx- imately 3 minutes. Briefly press the START/STOP button to reactivate the electrical system when re- quired. 5. Press the VTS DOWN button (or the iBR DOWN button on the iBR Activation page in B.U.D.S.), and read the iBR module motor output voltage. smr2009-038-003_a 1. 3 pin connector 2. 12 pin connector iBR MOTOR VOLTAGE TEST Battery voltage (over 12 Vdc) NOTE:

The 3 pin connector provides battery power directly to the iBR module for the actuator motor through a 30 A fuse. The 12 pin connector provides BRLS signals, CAN bus, and a switched 12 Vdc power to the iBR module through a 5 A fuse. 2. Set the FLUKE 115 MULTIMETER (P/N 529 035 868) to Vdc selection. 3. Measure for the 30iA battery input voltage to the iBR actuator as per following table. NOTE: Voltage measured should be battery volt- age in both UP or DOWN directions. Voltage po- larity should reverse as UP or DOWN button is pressed alternately. If battery voltage is not measured , refer to iBR ACTUATOR INPUT VOLTAGE TEST in this sub- section.

If battery voltage is measured in both direc- tions, refer to iBR POWER TEST USING A TEST LIGHT in this subsection. If battery voltage is measured and the test light is bright for both iBR UP or DOWN selections, the iBR motor is at fault and the iBR actuator must be replaced. If battery voltage is low or test light is dim in both directions, refer to iBR ACTUATOR INPUT VOLTAGE TEST in this subsection. If battery voltage is measured and test light is dim in one direction, replace the iBR actuator. iBR Power Test Using a Test Light 1. Connect the clip of a 12 Vdc test light to the battery ground (or engine ground). 2.

Touch the test light probe to each pin of the motor output connector on the iBR module as you select the iBR up and down alternately. The test light should come on bright for one pin only in each direction (alternating 12 Vdc and ground with change of iBR direction). smr2009-038-027_a iBR 12 PIN CONNECTOR PIN-OUT A. Connector keys 390 smr2009-037 iBR ACTUATOR INPUT VOLTAGE TEST (30 AMP BATTERY POWER) 3 PIN CONNECTOR BATTERY READING Pin 2 Pin 1 - Battery voltage Pin 2 - Neg. (-) post