Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) smr2009-038-022_a TYPICAL - WORN AND DEFORMED PLASTIC BUSHING smr2009-038-025_a TYPICAL - WEAR MARK ON VTS RING AND iBR GATE CONTACT POINTS 1. Wear mark on VTS ring 2. Wear mark on iBR gate NOTE: Wear marks on VTS ring and iBR gate con- tact points are normal up to 3.175 mm (.125 in). This wear affects nozzle backlash, not iBR gate backlash. 4. Replace parts as required. NOTE: Friction sleeves should be replaced as specified in maintenance chart or if they show signs of wear (flat surfaces).

Plastic bushings are press fit and should be replaced if they show signs of wear, deformation, or if the iBR gate backlash is beyond service limit. 3. Inspect VTS ring and iBR gate contact points for signs of wear. smr2009-038-023 Steering Nozzle Removal 1. Remove the 2 hexagonal screws securing the steering arms (links) to the steering nozzle (top and bottom). smr2009-038-012_b 1. Hexagonal screws to remove (top and bottom) 2. Remove the 2 socket head screws securing the nozzle to the VTS trim ring (1 top and 1 bottom). smr2009-038-024_a TYPICAL - WEAR MARK ON VTS RING AND iBR GATE CONTACT POINTS 1. Wear mark on VTS ring 2. Wear mark on iBR gate smr2009-037 395