Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) iBR GATE SUPPORT PLATES NOTE: Two locking tabs on the inner plate locks it to the outer plate exhaust nozzle. 5. Using a small screwdriver or a scriber, lift the upper locking tab slightly to help release the plates and avoid breaking the tabs. iBR Gate Support Plate Removal NOTE: The following steps must be carried out when removing the LH or RH support plates. 1. Open the boarding platform. 2. Remove the following listed items, see proce- dures in this subsection: iBR gate, VTS trim ring, and the steering noz- zle as an assembly iBR "U" arm. RH Support Plate Removal 1. Remove the RH storage bin, refer to the BODY subsection. 2.
Remove the battery, refer to CHARGING SYS- TEM subsection. 3. Disconnect the exhaust hose from the RH inner support plate. smr2009-043-003_a 1. Locking tab x2 (top and bottom) 6. Carefully pull the RH inner support plate off the outer plate. smr2009-043-001_a 1. Exhaust hose 2. Clamp to loosen 4. Remove and discard the 2 hexagonal screws securing the outer support plate to the inner support plate. smr2009-043-004_a 1. RH inner support plate 7. Pull the outer plate off the hull. LH Support Plate Removal 1. Remove the iBR actuator, refer to procedure in this subsection. 2. Cut the locking ties and disconnect the 2 bailer hoses from the jet pump venturi. smr2009-043-002_a 1.
Support plate retaining screws 398 smr2009-037