Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) smr2009-043-006_a TYPICAL 1. Bailer hoses (x2) 2. Intercooler bleed hose 3. Pump water pressure hose smr2009-039-002_a 1. Bailer hoses 3. Loosen the gear clamp and disconnect the wa- ter pressure hose from the jet pump. 6. Remove the FITTING PLATE from the support plate as described in this subsection ( this step is only applicable to models with a metal re- tainer on the support plate ). 7. Remove and discard the 5 hexagonal screws securing the outer support plate to the inner support plate. smr2009-039-003_a 1. Water pressure hose smr2009-043-011_a TYPICAL - MODEL WITH PLASTIC RETAINING TABS ILLUSTRATED 1.
Hexagonal screws to remove 2. Outer support plate 4. Remove the LH storage bin, refer to the BODY subsection. 5. Disconnect the four hoses connected to the fit- ting plate mounted in the iBR support plate. 8. From the iBR actuator side, carefully com- press the outer support plate tab retaining the two support plates together using a common screwdriver. smr2009-037 399