Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) 4. Install 5 new hexagonal screws to secure iBR support plates and torque as per exploded view. 5. Install the fitting plate, refer to FITTING PLATE in this subsection. 6. Install remaining parts in reverse order of re- moval. Refer to appropriate subsections for procedures, products and torques. FITTING PLATE The fitting plate connects the bailer and pressure hoses inside the hull to the hoses that are con- nected to the jet pump. It also provides the drain fitting for the intercooler drain hose. smr2009-043-008_a TYPICAL - MODEL WITH PLASTIC RETAINING TABS ILLUSTRATED 1. Fitting plate tab 2. Inner plate tab 3.

Outer plate tab to compress Fitting Plate Removal Models With a Metal Retainer on Fitting Plate NOTE: The metal fitting plate retainer in the fol- lowing step is applicable to certain models. 1. Remove the iBR actuator for access to the fit- ting plate, refer to iBR ACTUATOR in this sec- tion. 2. Disconnect the four hoses connected to the fit- ting plate (inside hull). 9. Pull the inner support plate off the outer support plate. 10. Pull the outer support plate from the hull. iBR Support Plate Installation RH Support Plate Installation 1. Ensure formed seals are in good condition and properly installed on each support plate. 2.

Position the RH inner support plate in front of its mounting position in the hull. 3. As you hold the inner support plate, insert ex- haust fitting on the outer support plate through the hull. Push the outer plate in until it snaps onto the inner plate. 4. Install 2 new hexagonal screws to secure iBR support plates and torque as per exploded view. 5. Install the exhaust hose on the support plate fitting and torque the gear clamp to 4 N•m (35 lbf• in ). 6. Install the battery, refer to CHARGING SYSTEM subsection. 7. Install remaining parts in the reverse order of removal. smr2009-043-006_a TYPICAL 1. Bailer hoses (x2) 2. Intercooler bleed hose 3. Pump water pressure hose 3.

Remove the hexagonal screw and metal re- tainer from the fitting plate. LH Support Plate Installation 1. Ensure formed seals are in good condition and properly installed on each support plate. 2. Position the LH inner support plate in front of its mounting position in the hull. 3. As you hold the inner support plate, insert the round extension on the outer support plate through the hull. Push the outer plate in until it snaps onto the inner plate. 400 smr2009-037