Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) smr2009-043-005_a TYPICAL 1. Hexagonal screw 2. Metal fitting plate retainer smr2009-039-003_a 1. Water pressure hose 4. Cut the locking ties and disconnect the 2 bailer hoses from the jet pump venturi. 6. Pull the fitting plate out of the outer support plate from the jet pump side. Models With Plastic Retaining Tabs on Fitting Plate NOTE: On models with plastic retaining tabs on the fitting plate, the procedure is the same as models with a metal retaining tab except for the following. 1. Compress the fitting plate retaining tab and pull the fitting plate from the outer support plate. smr2009-039-002_a 1. Bailer hoses 5.

Loosen the gear clamp and disconnect the wa- ter pressure hose from the jet pump. smr2009-043-012_a 1. Fitting plate tabs 2. Discard the fitting plate. NOTICE When the fitting plate retaining tabs are compressed for removal, the tabs become deformed and weakened. Do not reinstall a used fitting plate. Always install a new fitting plate. Failure to comply with this notice can result in water seeping into the bilge. smr2009-037 401