Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) Fitting Plate Installation Models With a Metal Retainer on Fitting Plate 1. Ensure the "O" ring seal is properly installed on the fitting plate and in good condition. 2. Insert the fitting plate through the outer iBR support plate. 3. Install the metal retainer and tighten the hexag- onal screw until it is snug. NOTICE Do not attempt to torque the hexag- onal screw or screw threads in the plastic fit- ting plate will be damaged. smr2009-043-007_a NEW FITTING PLATE 1. Good retaining tabs smr2009-043-005_a 1. Hexagonal screw 2. Metal retainer smr2009-043-009_a OLD FITTING PLATE (DO NOT REUSE) 1.
BAD retaining tabs (compressed and deformed) 4. Install the four hoses on the inner fitting plate. Torque gear clamps to 1.7 N•m (15 lbf• in ). smr2009-043-010_a OLD FITTING PLATE (BAD RETAINING TAB CONTACT) 1. Retaining tab smr2009-043-006_a TYPICAL 1. Bailer hoses (x2) 2. Intercooler bleed hose 3. Pump water pressure hose 5. Install the three hoses on the jet pump. 6. Torque the gear clamp securing pressure hose to the jet pump to 1.7 N•m (15 lbf• in ). 402 smr2009-037