Section 02 ENGINE Subsection 01 (ENGINE REMOVAL AND INSTALLATION) Check tightness and condition of engine rubber mounts. Refer to ENGINE MOUNTS in this sub- section. Before completely lowering engine, install ground cable, starter cable and both cooling hoses on ex- haust manifold. Follow these guide lines. Ensure contact surface is perfectly clean then reconnect grounds cable to engine. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of ground cable screw or use a new screw with self-locking product. Tighten ground cable screw to 23 N•m (17 lbf•ft). Torque starter cable nut to 7 N•m (62 lbf• in ). Install protective cap over the starter cable end.
Connect exhaust manifold water inlet and outlet hoses. Tighten clamps to 1.7 N•m (15 lbf• in ). Place engine into vehicle. Install engine support screws. Do not apply threadlocker to engine support screws and do not torque yet. Align engine. Refer to ENGINE ALIGNMENT in this subsection for complete procedure. Install and properly align exhaust pipe. Refer to EXHAUST SYSTEM subsection. Reinstall all other removed parts. Check hose condition and pressure test fuel sys- tem, refer to FUEL SYSTEM. smr2009-016-026_a 1. Ground cable screw on cylinder block 37. Carry on engine lifting to remove it from the body opening. NOTICE Be careful not to scratch body or to hit any component. 38.
Install the engine on an engine stand. WARNING Whenever doing any type of repair on wa- tercraft or if any components of the fuel sys- tem are disconnected, a pressure test must be done before starting engine. Verify all electrical connections (ground wires and battery). Run engine and ensure there is no leakage. NOTE: A special mounting plate is required to fix engine to support. This plate is not sold by BRP. NOTICE If watercraft is out of water, exhaust system must be cooled using the flush kit. Engine Installation Installation of engine in watercraft is essentially the reverse of removal procedures. However pay particular attention to the following.
Engine Alignment Before beginning this procedure, install the ALIGN- MENT SHAFT ADAPTER (P/N 529 035 719) on the end of the ALIGNMENT SHAFT (P/N 295 000 141) . NOTICE Whenever engine is removed from watercraft, engine alignment must be per- formed at reinstallation. Wipe off any spillage in bilge. Clean with the PUL- LEY FLANGE CLEANER (P/N 413 711 809) . 20 smr2009-016