Section 02 ENGINE Subsection 01 (ENGINE REMOVAL AND INSTALLATION) 529036170 ENGINE ALIGNMENT PLATE Trace two thin lines on alignment shaft. One at 739 mm (29-3/32 in) and the other at 742 mm (29-7/32 in). smr2009-016-027_a 1. Engine alignment plate 2. Engine alignment support smr2009-016-200_a A. 739 mm (29-3/32 in) B. 742 mm (29-7/32 in) 3. Secure the tool on ride plate using jet pump socket screws. NOTE: To perform this procedure the jet pump and the drive shaft must be removed. Refer to JET PUMP and DRIVE SYSTEM subsections. To verify alignment proceed as follows: 1. Remove the sealing ring and the drive shaft boot. Refer to DRIVE SHAFT subsection. 2.
Install the ALIGNMENT SHAFT SUPPORT (P/N 529 035 506) on the ENGINE ALIGNMENT PLATE (P/N 529 036 170) . smr2009-016-028_a 1. Jet pump socket screws 4. Install the ALIGNMENT SHAFT ADAPTER (P/N 529 035 719) in engine PTO housing. 529035506 ALIGNMENT SHAFT SUPPORT smr2009-016 21