Section 02 ENGINE Subsection 01 (ENGINE REMOVAL AND INSTALLATION) NOTE: Use shim(s) (P/N 270 000 770) for the front engine mount and shim(s) (P/N 270 000 762) for the rear engine mounts. Shims location is between engine mount and engine mount plate. NOTICE Whenever shims are used to correct alignment, never install more than 5 shims. smr2009-016-029_a 1. Engine alignment adaptor 5. Carefully slide the ALIGNMENT SHAFT (P/N 295 000 141) into the engine alignment support. smr2009-016-032_a REAR STARBOARD ENGINE MOUNT SHOWN 1. Engine mount 2. Engine mount screws 3. Shim 4. Engine mount plate 10. When engine alignment is correct, check the longitudinal position of engine. smr2009-016-030_a 1.
Alignment shaft 2. Engine alignment support Engine Longitudinal Position Verification With alignment shaft installed, check the location of the marks (previously drawn at the beginning of the engine alignment procedure). Engine is properly positioned longitudinally when the end of the alignment shaft support is between both shaft marks. If one mark is visible, the engine is properly po- sitioned. If both marks are visible, the engine must be moved forward. If no mark is visible, the engine must be moved rearward. 6. Insert alignment shaft end into alignment shaft adapter. If the alignment is correct, the align- ment shaft will slide easily without any deflec- tion in alignment shaft adapter.
smr2009-016-031_a 1. Alignment shaft 2. Alignment shaft adapter 7. If the alignment is correct, check the longitudi- nal position of engine. See procedure further. 8. If the alignment is incorrect, loosen engine mount screws to align engine. 9. Add or removed shims as required. smr2009-016-201_a PROPER POSITION 1. Alignment shaft support end 2. Mark at 742 mm (29-7/32 in) 22 smr2009-016