Section 06 STEERING AND PROPULSION Subsection 03 (JET PUMP) Sacrificial Anode Removal Unscrew sacrificial anode hexagonal screw and remove anode. smr2009-006-002_a TYPICAL 1. Small leak here is acceptable 6. Disconnect pump and remove pressure cap. 7. Reinstall impeller cover. Refer to IMPELLER COVER in this subsection. smr2006-027-009 Sacrificial Anode Installation Installation is the reverse of the removal proce- dure. Torque anode retaining screw as specified in ex- ploded view. PROCEDURES NOTE: Whenever removing a part, visually check for damage such as:
corrosion, cracks, split, break, porosity, cavitation, deformation, distor- tion, heating discoloration, wear pattern, defec- tive plating, missing or broken balls in ball bearing, water damage diagnosed by black-colored spots on metal parts, etc. Renew any damaged part. As a quick check, manually feel clearance and end play, where applicable, to detect excessive wear. JET PUMP HOUSING NOTE: The jet pump housing can be removed as an assembly with the venturi. This is the preferred procedure when either the drive shaft or engine removal is required. SACRIFICIAL ANODE Jet Pump Housing Removal 1. Remove the iBR gate and VTS trim ring, refer to iBR AND VTS subsection. 2.
Cut locking ties and disconnect both bailer hoses from the venturi. Sacrificial Anode Inspection Check for wear. If worn more than half, replace anode. smr2009-039-009_a 1. Sacrificial anode location smr2009-039-002_a 1. Bailer hoses smr2009-039 411