Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 03 (JET PUMP) 3. Loosen gear clamp and remove the hose from the water pressure outlet fitting on the jet pump housing. Jet Pump Housing Inspection and Cleaning 1. Visually inspect jet pump housing. Pay atten- tion to the stator. Ensure the assembly is clean and free of any debris and defects. 2. Blow low pressure compressed air through the pressure outlet fitting and make sure it is clear. 3. Ensure the neoprene seal is in good condition. Replace as required. smr2009-039-003_a 1. Water pressure hose 4. Remove the socket screws that retain the 4 jet pump adapters to the ride plate. smr2009-039-005_a 1. Pressure hose fitting 2. Neoprene seal NOTE:

The end of the pressure outlet fitting screwed into the pump housing is perforated with many small holes. These holes must remain clear to ensure an adequate water supply for the intercooler and exhaust system. smr2009-039-004_a 1. Socket screws to remove (x4) 5. Pull back jet pump housing to remove it from the pump support. It may be necessary to wig- gle it slightly as you pull back on the pump. NOTE: The jet pump housing is held tightly in the pump support due to the neoprene seal at the for- ward end of the pump. There are no fasteners se- curing the jet pump housing to the pump support. smr2009-039-010_a 1. Fitting 2. Holes in fitting 4. Check the 4 pump adapters.

Ensure they are free of any cracks. NOTE: Do not remove the jet pump housing adapters from the pump unless it is necessary to do so. 412 smr2009-039