Section 06 STEERING AND PROPULSION Subsection 03 (JET PUMP) 2. Install the pump on a spare ride plate, the mounting screws should be tight, but it is not required to torque them. 3. Torque hexagonal screws retaining the adapters to the jet pump housing as speci- fied in the exploded view. 4. Remove the jet pump housing from the spare ride plate and install it on the watercraft ride plate. Jet Pump Housing Installation Brush and clean impeller splines and drive shaft splines with PULLEY FLANGE CLEANER (P/N 413 711 809) or equivalent. Splines must be free of any residue.
Lubricate drive shaft splines, impeller splines and the inside of the impeller boot with XPS SYNTHE- TIC GREASE (P/N 293 550 010) . NOTE: Slightly lubricate wear ring with XPS LUBE (P/N 293 600 016) to minimize friction during initial start. Ensure the neoprene seal is properly installed on the jet pump. smr2009-039-006_a 1. jet pump housing adapters (x4) Jet Pump Housing Adapter Replacement Adapters incorporate a keyway at the pump hous- ing end of the adapter that provide for a small amount of play for mounting the jet pump. smr2009-039-007_a 1. Adapter key smr2009-039-005_b 1.
Neoprene seal While holding the pump housing with the pump adapters downwards, align the pump with the drive shaft and carefully push the pump into the pump support. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on the adapter screw threads (or use new self-locking screws). Torque screws retaining pump adapters to ride plate as specified in exploded view. smr2009-039-008_a 1. Pump housing adapter keyway If adapters are removed or replaced, or a new pump housing is installed, adapters may be aligned to the pump housing using a spare ride plate as a jig. Carry out the following steps. 1. Install the four adapters on the jet pump hous- ing leaving the hexagonal screws slightly loose.
smr2009-039 413