Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 03 (JET PUMP) VENTURI Venturi Removal Jet Pump Housing installed 1. Remove the iBR gate and VTS trim ring as an assembly. Refer to iBR AND VTS subsection. 2. Cut locking ties and remove the 2 bailer hoses from the venturi. 3. Refer to JET PUMP HOUSING REMOVED to continue procedure. Jet Pump Housing Removed 1. Remove the three hexagonal screws retaining the venturi to the jet pump housing. ' TYPICAL 3. Using a fiber hammer, gently tap impeller cover to help release it from the jet pump housing. 4. Use a flat screwdriver in the slots provided as pry points to remove it from the jet pump hous- ing. smr2009-039-002_b 1. Bailer hoses 2.

Venturi retaining screws (x3) Venturi Installation The installation is the reverse of the removal pro- cedure. Pay attention to the following. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of venturi screws or install new self-lock- ing screws. Install venturi screws and flat washers. Torque venturi hexagonal screws to 21 N•m (15 lbf•ft). Ensure bailer hoses and fittings are in good condi- tion. sdd2009-001-114_b 1. Slot IMPELLER COVER Impeller Cover Removal 1. Remove the venturi. 2. With pump housing in vertical position, remove and discard the 3 retaining screws. '+ TYPICAL 414 smr2009-039