Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) Reinstall reservoir plug and tighten it to 1 N•m (9 lbf• in ). If the current draw is excessive, replace the hy- draulic pump. Hydraulic Pump Operation Test Connect a jumper from the positive (30 A fused jumper) and negative side of the battery to the hy- draulic pump connector (2-pins connector). The hydraulic pump should activate and suspen- sion should go up or down. Reverse the jumpers and the suspension should reverse direction. If the hydraulic pump does not run, check con- nectors and wires. Replace hydraulic pump as re- quired. If hydraulic pump turns, perform the HYDRAULIC PUMP CURRENT DRAW test to confirm pump op- eration.

Hydraulic Pump Removal (as a Unit with Actuator) To work on many parts of suspension system, the removal of the hydraulic pump and actuator as an unit is necessary. 1. Remove SHOCK ABSORBER and SPRINGS. See procedures in this subsection. 2. Unplug the hydraulic pump connector from the iS module. 3. Cut any locking ties securing the pump harness to vehicle harness. 4. Remove clamp and bolt securing the hydraulic pump from suspension base. Hydraulic Pump Current Draw If the current draw is to high, the iS module acti- vates an internal protection. This operation can be done using B.U.D.S. soft- ware. Refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE subsection to connect B.U.D.S.

Activate the suspension by pressing iS up and iS Down s and check voltage. smr2009-041-016_b 1. Hydraulic pump clamp 2. Retaining bolt 5. Remove actuator link bolt. smr2009-041-053_a ACTIVATION AND IS TABS 1. B.U.D.S. ammeter 2. iS UP 3. iS down smr2009-041-029_a 1. Actuator link bolt 2. Link support on the top of suspension base 6. Remove screws retaining the actuator holder. If values is near specifications, check connections and wires. If wires and connectors are good, perform the iS module output voltage test. Refer to IS MODULE in this subsection. 454 smr2009-041 CURRENT iS UP 16 - 20 A iS Down 15 - 18 A