Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) smr2009-041-028_a 1. Actuator holder screws 7. Remove the suspension position sensor to avoid damaging it. 8. Remove screws securing both rear ends of front suspension arm to suspension base. smr2009-041-045_a VIEW FROM THE REAR OF VEHICLE 1. Secure hydraulic hose to hydraulic pump 2. Secure hydraulic hose, fuel hose and vehicle wiring harness smr2009-041-046_a VIEW FROM THE FRONT OF VEHICLE 1. Position both ends of hydraulic hose on same side smr2009-041-027_a 1. Retaining screws Install the FRONT SUSPENSION ARM. See pro- cedure in this subsection. 9. Lift the rear of the front suspension arm to make room for hydraulic pump. 10.
Remove hydraulic pump with actuator by lifting them through the suspension bellows opening. Hydraulic Pump Removal (Without Actuator) 1. Remove the deck extension. Refer to BODY subsection. 2. Remove the air intake tube. Refer to AIR IN- TAKE SYSTEM subsection. 3. Unplug the hydraulic pump connector from the iS module. 4. Cut any locking ties securing the pump harness to vehicle harness. 5. Cut locking tie securing the hydraulic hose to pump. Hydraulic Pump Installation (as a Unit with Actuator) The installation is essentially the reverse of the re- moval procedure. However, pay attention to the following. Make sure to secure the actuator link to suspen- sion base.
Tighten actuator link bolt to 25 N•m (18 lbf•ft). NOTICE Failure to do so might result in spring failure. Hydraulic hose routing is very critical to avoid problems with hydraulic unit. Use the following illustration to route and attach the hydraulic hose properly. smr2009-041 455