Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) 4. Secure hydraulic pump to suspension base. 4.1 Install pump retaining screw and tighten it to 10 N•m (89 lbf• in ). 4.2 Install retaining clamp and tighten it to 2 N•m (18 lbf• in ). 5. Secure hose to reservoir with a new locking tie. 6. Route pump harness and secure it with new locking ties. 7. Connect the hydraulic pump connector to iS module. 8. Install a weight of 90 kg (200 lb) on moving deck and using suspension controls on steer- ing, cycle the suspension fully up and fully down 3 times. This action will remove air bubbles trapped into hose and pump during installation. 9. Check for leaks. 10. Install all other removed parts.

smr2009-041-048_a 1. Retaining screws 2. Alignment support 4. Turn actuator up side down and remove hy- draulic hose. ACTUATOR Actuator Inspection Check actuator for leaks at hose opening and around inner piston. Replace actuator if any leak is detected. smr2009-041-049_a 1. Retaining socket screw 2. Hydraulic hose lock Actuator Removal 1. Refer to HYDRAULIC PUMP REMOVAL (AS A UNIT WITH ACTUATOR) and remove the pump from the vehicle. 2. Remove and discard the screw securing actua- tor link to alignment support. 5. Remove and discard the three socket screws securing actuator holder halves and split the ac- tuator holder. smr2009-041-050_a 1. Socket screws 2.

Actuator holder halves Actuator Installation The installation is the reverse of the removal pro- cedure. However, pay attention to the following. Install hydraulic hose in accordance with the fol- lowing illustration. smr2009-041-047_a 1. Actuator link 2. Retaining screw 3. Alignment support 3. Remove the alignment support from actuator holder. Discard screws smr2009-041 457