Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) smr2009-041-052_a 1. Hose fully inserted in lock slot 2. Position hydraulic hose in lock hook smr2009-041-023_a 1. Lateral support screw 4. Remove lateral support from lateral bellows. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of lock screw. Tighten screw to 8 N•m (71 lbf• in ). Install the hydraulic pump in vehicle. Make sure to route the hydraulic hose properly. See HY- DRAULIC PUMP INSTALLATION (AS A UNIT WITH ACTUATOR) in this subsection. Install a weight of 90 kg (200 lb) on moving deck and using suspension controls on steering, cycle the suspension fully up and fully down 3 times.

This action will remove air bubbles trapped into hose and pump during installation. Check for leaks. Install all other removed parts. Lateral Support Installation The installation is the reverse of the removal pro- cedure. However, pay attention to the following. Apply soapy water solution on bellows opening and insert the lateral support. Index lateral supports with the front suspension shaft ends. Lateral supports can be inserted in one position only. Tighten lateral support screw to 48 N•m (35 lbf•ft). Install a new Oetiker clamp. Position the ear of clamp rearwards. LATERAL SUPPORT Lateral Support Removal NOTE: The following instruction can be used for RH or LH support. 1.

Remove the moving deck. Refer to BODY sub- section. 2. Cut the Oetiker clamp retaining lateral bellows to lateral support. smr2009-041-066_a RH SIDE SHOWN 1. Ear of clamp rearwards LATERAL BELLOWS Lateral Bellows Removal 1. Remove lateral support screw. smr2009-041-022_a 1. Lateral support 2. Oetiker clamp 3. Remove the lateral support screw. 458 smr2009-041