Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) smr2009-041-026_a 1. Ring pin 2. Bellows alignment hole 3. Body hole smr2009-041-024_a 1. Lateral support screw 2. Decouple lateral support from suspension shaft. 3. Using the SUPERTITANIUM DRILL BIT 3/16" (P/N 529 031 800) , remove all rivets (12) secur- ing the lateral bellows ring to body. Install new rivets. If the head of rivet tool can- not be inserted in ring opening, use the sleeve (P/N 707 000 181) to offset the rivet tool and well lean the rivet head against ring. Index lateral supports with the front suspension shaft ends. Lateral supports can be inserted in one position only.
Tighten lateral support screw to 48 N•m (35 lbf•ft). Install a new Oetiker clamp. Position the ear of clamp rearwards. 529031800 smr2009-041-025_a 1. Rivet location 4. Remove lateral ring. 5. Cut Oetiker clamp securing bellows to lateral support. 6. Separate lateral support from bellows. smr2009-041-066_a RH SIDE SHOWN 1. Ear of clamp rearwards FRONT SUSPENSION ARM Lateral Bellows Installation The installation is the reverse of the removal pro- cedure. However, pay attention to the following. Apply soapy water solution on bellows opening and insert the lateral support. Index suspension shaft with the lateral support. The lateral support can be inserted in one position only.
Install the retaining ring. Align the ring pin with holes in bellows and body. Front Suspension Arm Removal 1. Remove the moving deck. Refer to BODY sub- section. 2. Remove the engine. Refer to ENGINE RE- MOVAL AND INSTALLATION subsection. 3. Remove both lateral support screws. smr2009-041 459