Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) 2. Using a marker, trace the shape of suspension base at the bottom of the hull to reposition it at the same place. 3. Remove and discard suspension base screws. smr2009-041-024_a RH SIDE SHOWN 1. Lateral support screw 4. Decouple lateral supports from suspension arm shaft. 5. Refer to HYDRAULIC PUMP REMOVAL (AS A UNIT WITH ACTUATOR) and remove the pump from the vehicle. 6. Remove screws securing both shaft supports to suspension base. 7. Move front suspension arm rearward to re- move it from the vehicle. smr2009-041-031_a STARBOARD SIDE 1.

Suspension base screws Front Suspension Arm Installation The installation is the reverse of the removal pro- cedure. However, pay attention to the following. If a shaft support has been loosen from the suspension arm shaft, see SUSPENSION ARM SHAFTS for proper installation procedure. smr2009-041-032_a PORT SIDE 1. Suspension base screws 4. Remove suspension base with the rear vent duct. smr2009-041-063_a 1. Shaft support (one on each side) SUSPENSION BASE smr2009-041-033_a 1. Suspension base 2. Rear vent duct Suspension Base Removal 1. Refer to the appropriate procedures and re- move the following parts:

Moving deck Engine Shock absorber and springs Hydraulic pump (with actuator) Suspension position sensor. 460 smr2009-041