Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) Suspension Base Installation The installation is the reverse of the removal pro- cedure. However, pay attention to the following. 1. Install the suspension base. 1.1 Position the base in accordance with the reference marks previously drawn at the bottom of the hull. NOTE: If no marks are available, see SUS- PENSION BASE INSTALLATION WITHOUT REFERENCE MARKS. 1.2 Install NEW suspension base screws. 1.3 Tighten suspension base screws to 25 N•m (18 lbf•ft). 2. Refer to the appropriate procedures and install all other removed parts. Actuator and hydraulic pump Front suspension arm Shock absorber and springs Engine Moving deck.
4.2 If required, move suspension base until both distances are equal. 4.3 Tighten suspension base rear screws to 25 N•m (18 lbf•ft). smr2009-041-065_a TIGHTENING SEQUENCE 5. Refer to the appropriate procedures and install all other removed parts. Actuator and hydraulic pump Shock absorber and springs Engine Moving deck. Suspension Base Installation Without Reference Marks 1. Install the suspension base in vehicle using NEW screws. Do not tighten them yet. 2. Install the front arm on suspension base and tighten screws to 25 N•m (18 lbf•ft), use the OLD screws. 3. Install lateral supports. 3.1 Index lateral supports with the front sus- pension shaft ends.
Lateral supports can be inserted in one position only. 3.2 Tighten lateral support screws to 48 N•m (35 lbf•ft). 4. Align suspension base in vehicle. 4.1 On both sides, measure the distance be- tween the end of lateral support and fixed deck. REAR SUSPENSION ARM Rear Suspension Arm Removal 1. Open the boarding platform. 2. Remove bolts securing both rear suspension arm covers. smr2009-041-072_a 1. Rear suspension arm cover 3. Unclip and remove both lateral rear panels. smr2009-041-064_a A. Same distance on LH and RH sides smr2009-041 461