Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 02 (BODY) Removing the Moving Deck for Servicing Watercraft 1. Open the front storage cover and remove the front basket. 2. Remove the BOARDING PLATFORM, see pro- cedure in this subsection. smr2009-042-066_a 1. Hoist 2. Lifting strap ssi2009-002-002_a 1. Boarding platform 3. Remove bolts securing both rear suspension arm covers. smr2009-042-023_a 1. Use this rivet as reference point A. 340 mm (13-1/2 in) NOTICE Lifting the rear of moving deck more than the recommended height can damaged the steering cable. Lowering Back Moving Deck 1. Carefully lower and secure the rear suspension arm to the fixed deck.

1.1 Position the rear suspension arm brackets in accordance with the reference marks previously draw on fixed deck. smr2009-042-010_a 1. Cover screws 4. Mark position of rear suspension arm brackets for proper reinstallation. 5. Remove and discard screws securing rear sus- pension arm to fixed deck. NOTICE If no mark was trace, refer to IS SUSPENSION subsection for proper pro- cedure to install and align the rear suspen- sion arm. 1.2 Install NEW screws to secure rear suspen- sion arm brackets. 1.3 Tighten screws to 25 N•m (18 lbf•ft). 2. Detach lifting device. 3. Remove pieces of wood located under the front of moving deck. smr2009-042 471