Section 07 BODY AND HULL Subsection 02 (BODY) smr2009-042-011_a 1. Rear suspension arm 2. Reinstallation marks 3. Screws (discard) smr2009-042-014_a RH SIDE SHOWN 1. Front carpet (discard) 2. Protective cap 6. Lift and attach the rear suspension arm against seat handle. 8.2 Remove and discard screws securing moving deck to lateral supports. smr2009-042-012_a 1. Seat handle 2. Ski/wakeboard attachment 3. Locking tie smr2009-042-015_a RH SIDE SHOWN 1. Retaining screws (discard) 7. Manually, tip up the front of moving deck and install a piece of wood (2 x 4) between fixed deck and each lateral supports. 9. Open seat. 10.
Remove and discard M8 hexagonal screws securing the suspension mounting plate and moving deck. smr2009-042-013_a FROM THE FRONT OF VEHICLE 1. RH lateral support 2. Piece of wood smr2009-042-016_a 1. Moving deck central screws (discard) 8. Detach moving deck from lateral supports. 8.1 Remove front carpet of foot wells and pro- tective caps on both sides of the moving deck. Discard the front carpets. 11. Close seat. 12. Remove the gauge support. Refer to GAUGE subsection. 13. Disconnect the four connectors under moving deck. 472 smr2009-042