Section 07 BODY AND HULL Subsection 02 (BODY) 10. Install two homemade alignment pins on sus- pension mounting plate. 10.1 Take two M8 x 50 bolts and cut their heads. 10.2 Make into a round shape the cut ends. 16. Carefully lower and secure the rear suspen- sion arm to the fixed deck. 16.1 Position the rear suspension arm brack- ets in accordance with the reference marks previously draw on fixed deck. NOTICE If no mark was trace, refer to iS SUSPENSION subsection for proper pro- cedure to install and align the rear sus- pension arm. 16.2 Install NEW screws to secure rear sus- pension arm brackets. 16.3 Tighten screws to 25 N•m (18 lbf•ft). 17. Remove rear lifting strap. 18.
Attach steering cable to steering column. 19. Install gauge support. Refer to GAUGE sub- section. 20. Install NEW front carpets on foot wells and protective caps on moving deck. 21. Check steering alignment then tighten steer- ing clamp bolts. Refer to STEERING subsec- tion. smr2009-042-073_a 10.3 Install alignment pins into the 2 rear out- side positions of suspension mounting plate. CARPETS Carpet Cleaning To clean the carpets, use 3M™Citrus Base Cleaner or the equivalent. See the manufac- turer's instructions. Carpet Removal Unstick a carpet corner. Pull carpet vigorously to remove the carpet and its glue from body. To remove the remaining glue from body, use a plastic or rubber spatula.
Scrape remaining glue with spatula. NOTE: Do not use any products (alcohol, ace- tone, thinner, etc.) or heat the remaining carpet glue. Chemical reactions make glue very hard to remove. smr2009-042-072_a 1. Alignment pins 11. Position the moving deck so that alignment pins are aligned with suspension reinforce- ment plate holes. 12. Lower the moving deck over alignment pins. 13. Install NEW M8 hexagonal screws to secure the moving deck to suspension mounting plate. NOTE: Remove the alignment pins only when 2 screws are engaged in mounting plate. 14. Tighten screws to 25 N•m (18 lbf•ft). 15. Close seat. Carpet Installation Clean body surface with isopropyl alcohol and dry thoroughly.
Install new carpet. smr2009-042 475