Section 07 BODY AND HULL Subsection 03 (HULL) Thru-Hull Fitting Removal Inner Fitting Removal 1. Remove drive shaft, refer to DRIVE SHAFT sub- section. 2. Using a heat gun, heat the glue at the joint be- tween the hull and the inner thru-hull fitting to soften the glue applied. smr2009-043-020_a 1. Apply loctite 5900 here (underside of pump support) 3. Torque jet pump support screws as specified in exploded view. smr2009-043-022_a 1. Heat here 3. Carefully remove overlapping glue from around the inner fitting. smr2009-043-019_a 1. Torque pump support screws (4x) 4. Remove any excess sealant from the right hand forward ride plate mounting hole. 5.
Reinstall all removed parts in the reverse order of removal. Refer to appropriate subsections for procedures. THRU-HULL FITTING The thru-hull fitting is composed of 2 pieces, an outer fitting, and an inner fitting that screws onto the outer fitting after the outer fitting is inserted in the hull. smr2009-043-031_a 1. Inner thru-hull fitting (overlapping glue removed) 4. Unscrew the inner fitting from the outer fitting using a 65 mm (2.56 in) socket. Outer Fitting Removal 1. Carefully cut sealant around the edge of the outer fitting (jet pump side). smr2009-043-024_a 1. Outer fitting 2. Inner fitting 504 smr2009-042