Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 03 (HULL) 2. Insert the outer fitting into the hull from the jet pump side of the hull towards the inside. En- sure fitting is pushed in against the hull. 3. Continue with INNER FITTING INSTALLATION procedure. Inner Fitting Installation 1. Apply DEVCON HP 250 Q completely around the joint where the outer fitting comes through the hull. smr2009-043-023_a TYPICAL 1. Cut sealant around outer fitting here 2. Heat the inside of the outer fitting to soften the sealant and help break the bond between the hull and fitting. 3.

Using a rubber mallet (or a hammer and a wooden block), hammer the outer fitting from the inside of the hull towards the outside, until it is flush with the hull. 4. Reach in through the pump support and pull the fitting out of the hull. smr2009-043-030_a 1. Apply glue here Hull Cleaning for Thru-Hull Fitting Installation 1. Scrape off all excess sealant from the hull on the outer fitting side. 2. Remove excess glue from the hull on the inner fitting side. 3. Clean hull surface with BRP HEAVY DUTY CLEANER (P/N 293 110 001) to eliminate grease, dust, and sealant residue. NOTE: Use only a clean, dry, oil free filtered air supply for dusting and drying parts or hull. 2.

Screw the inner fitting onto the outer fitting and torque as specified in the exploded view. 3. Using a tongue depressor (or popsicle stick), smooth out glue over the hull and inner fitting joint. Outer Fitting Installation 1. Apply a bead of LOCTITE 5900 (P/N 293 800 066) sealant completely around the outer edge of the fitting (pointed end), and another bead across the top of the fitting. smr2009-043-022_a 1. Smooth out glue here over edge of inner fitting 4. If the outer fitting was replaced, ensure it is properly seated against the hull in the jet pump area. Remove excess sealant at the joint be- tween the outer fitting and hull. smr2009-043-029_a 1.

Apply Loctite 5900 here smr2009-042 505