8 Encoder diagnostics | Diagnostics for encoders with 1 V PP /11 µA PP /1 V PP + Z1 interface Analysis information screen Figure 34: Analysis information screen The Analysis information screen shows messages on the signal analysis. The messages depend on the encoder functions. You can reset the messages.
Classification of signal messages Message Category Description Frequency exceeded Signal evaluation Signal frequency too high, the testing tolerances can no longer be guaranteed Reference mark not correctly detected Signal evaluation The reference mark was not correctly detected Opening Analysis information Tap More The More menu is opened Tap Analysis The Analysis information screen is opened Clearing status messages Correct the error(s) displayed in the status message Tap Delete Status messages about errors that have been corrected will be deleted. Status messages about errors that continue to exist will continue to be displayed.
If required, repeat this procedure until all pending status messages have been deleted Tap Back The screen that was last selected is opened. HEIDENHAIN | PWT 100, PWT 101 | Operating Instructions | 07/2024 93