BAIC BJ2021 and BJ2022 series light-weight off-road vehicles — Start and stop the vehicle

Start and stop the vehicle 107 The lengths of these screws are not exactly the same, the screws in the -A- position shown in the figure are slightly shorter than the screws in the -B- position shown in the figure, so be careful not to confuse them when installing. In addition, these screws have a torque requirement of 20±2N·m during installation. Attention 2 Pull out the wiper arm from the wiper motor shaft by the puller (pay attention to the installation position when removing, so that it can be used normally when it is restored). 9.

Remove the round head screws that fix the lower windshield triangular plates on the left and right sides of the front windshield, 6 on each side, 12 in total, and remove the windshield triangular plates (the picture here takes the right side of the vehicle as an example). A A B A A A