BAIC BJ2021 and BJ2022 series light-weight off-road vehicles — Starting and Driving

Starting and Driving 151 Electronic burglar alarm function smart remote key backup start function Automatic transmission models: the engine can be started only when the shift lever is in P or N and the brake pedal is pressed. Manual transmission models: the clutch pedal must be pressed be­ fore the engine can be started. For safety reasons, it is strongly rec­ ommended to put the shift lever in the neutral position before starting the engine. Press the start / stop button to start the engine or switch the power mode, but it must be ensured that the smart remote key is placed in the effective area that can be de­ tected by the vehicle.

Tip The electronic burglar alarm function is used to prevent others from illegally stealing vehicles. The transceiver chip in the remote key is equipped with an electronic code which is sent to the vehicle. The engine can be started only when the electronic code of the transceiver chip is consistent with the registered vehicle ID code. If an improperly coded key (or other device) is used, the engine’s fuel system is disabled.

Driving automatic locking function / flameout unlocking If the vehicle is in a strong signal interference area, or when the battery of the smart remote key is low, when you press the "Start/Stop button" to try to start the vehicle, the "smart remote key not found" will be displayed on the trip computer display on the instrument. At this time, the standby start function is required. Vehicles with automatic transmission: When the gear is in the "P/N" gear position, press the brake pedal, place the smart remote key in the key identification position designated by the cup holder, and press the start/stop button to start the engine. Vehicles with manual transmission:

When the gear is in the "neutral" gear position, press the clutch pedal, place the smart remote key in the key identification position designated by the cup holder, and press the start/stop button to start the engine. 3 When all doors are locked, after unlocking the doors with the smart remote key, none of the four doors and two covers has been opened within 30 seconds, and the central door lock will automatically lock. When the vehicle speed is higher than the set value during driving, the central door lock will automatically lock all doors. When the vehicle stalls, the door will unlock automatically.