Brake system 174 Working Mode of ABS Anti-lock Braking System Never release the brake pedal before the vehicle stops or the danger is over! It is also not allowed to repeatedly press the brake pedal, which will stop the work of ABS and may increase the braking distance. If the road is slippery, ABS will be enabled even if the brake pedal is lightly pressed, so that the driver can obtain the road characteristic information through braking, and then adjust his driving style. ABS system warning light ABS integrates a monitoring system to check whether all system related electrical components are working properly in real time. When the ABS system fails, the ABS warning light is on.
When the start/stop button is in the "RUN" position during the vehicle self-test, the light will be on for 2~3 seconds and then off. Make sure that the light is off before the vehicle is driven. When the ABS system warning light is on while driving, do not brake hard at this time, otherwise the vehicle may be in danger of unstable driving. Always depress the brake pedal gently and park the vehicle in a safe place. Restart the engine and check if the warning light goes out after a few minutes of driving. If the warning light goes out while driving, there is no problem. If the warning light does not go off, or if the warning light comes on again while driving.
Please contact the special dealer of BAIC for inspection and repair as soon as possible. When the vehicle speed reaches about 20km/h, an automatic detection process is started. At this time, the running sound of the pump can be heard. ABS cannot shorten the braking distance on gravel and snow-covered roads, however, it can still allow the driver to control the vehicle steering because the wheels will not be completely locked. When the ABS system works, you can feel the brake pedal shaking and hear the clicking sound at the same time, which is a normal phenomenon.
If the speed range of a wheel is too low relative to the vehicle speed and tends to lock up, the ABS will reduce the brake pressure on the wheel. This adjustment process can be detected by the noise of the brake pedal. From this, as a driver, you know that the wheels are tending to lock (ABS adjustment range). At this time, keep the brake pedal completely depressed and control the vehicle out of danger. 3 WARNING Any ABS braking system shall not vi olate the physical principle. Therefore, please develop good driving habits and do not use the advantages of ABS system to drive fast.
To achieve the shortest braking dis tance possible and to improve trajec tory stability on wet and dry roads, brake as hard as possible and perform emergency avoidance operations as necessary.