Spare tire and in-vehicle tool 261 Only after loosening the nut of the replacement wheel can the lifting and subsequent replacement be carried out. Attention WARNING Make sure the jack is on firm and level ground. Make sure the jack is placed under the proper jacking point. Follow the precautions for operat ing the jack. Disconnect your vehicle from the trailer (if equipped). When you raise the vehicle, contin ually observe the condition of the vehicle. If you observe the vehicle inclines obviously, stop raising it and find out the cause before trying again.
First assemble the special wrench for Jack, extension rod for special wrench for Jack and wheel assembly wrench as shown in the figure. Rotate the jack clockwise to lift the vehicle by the assembled tool ntil the flat tire leaves the ground. First remove the wheel nuts, and then remove the flat tire. Be careful when handling the wheel nuts, because the wheel nuts may become very hot due to driving. After removing the flat tire, place it on the ground with its outer surface facing up. 5