WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 64 XX — RETARDER MODULATION REQUEST DEVICE FAULT 6–98 Copyright © 2001 General Motors Corp. Letter 16-WT-96 for the correct procedure. Be sure to reset the ECU to unadapted shifts when it is returned to the original vehicle. 4. If the condition persists, replace the ECU with a test diagnostic ECU (P/N must match and it is recommended that the controller be loaded with the latest version of the CIN). If replacing the ECU corrects the problem, reinstall the original (bad) ECU to confirm that the problem is in the ECU.
If the original ECU now works, inspect the ECU connectors for corrosion or damage which may cause an intermittent condition. If the original problem recurs, install a replacement ECU. . Table 6–8.
RMR Device Resistance Checks Resistance Check in Resistance Module* Voltage Signal ** Wiring to Control Device Description Terminals Resistance ± 5% % Retarder Application Voltage ± 0.2 v Device Terminal Auto Full On A to C 12K 100 3.6 No connections Pressure Switch Full On High A to C 32K 0 100 1.1 3.6 A B 3-Step E-10R Bendix Pedal A to C 32K 0 32 58 100 1.1 1.9 2.8 3.6 A B C D 6-Step Hand Lever — Off Position 1 Position 2 Position 3 Position 4 Position 5 Position 6 A to C 32K 0 14 28 45 65 82 100 1.1 1.5 1.9 2.3 2.8 3.2 3.6 + 1 2 3 4 5 6 Auto 1⁄ On 2 A to C 12K 50 2.4 No connections 3 Pressure Switches— Low Medium High A to C 32K 0 32 68 100 1.1 1.9 2.8 3.6 A B A B A B Auto 1⁄ On 3 2 Pressure Switches Auto Medium High A to C 21.4K 32 68 100 1.9 2.8 3.6 A B A B Dedicated Pedal No Checks Interface not a resistance module 0 100 0.7 – 1.2 3.4 – 3.5 A B C * Resistance module must be disconnected from the wiring harness and retarder control devices ** These voltages must be measured between terminals A and B.